Husqvarna Transaxle Fluid. HUSQVARNA HUSQVARNA 10W50 AWD Transmission Oil HUSQVARNA from Gayways UK To ensure constant fluid quality levels and longer life, an oil filter change interval of every 200 hours is recommended During the filling process connect a drill to the fan/pulley shaft and spin the transaxle to purge the air out of the system allowing room for more fluid.
Husqvarna YTH 180 (954140010D) (199712) Parts Diagram for Transaxle from www.jackssmallengines.com
Thought I might drain and refill the fluid at this point with almost 400 hours on the unit After the oil has drained, wipe the filter base surface and apply a film of new oil to the gasket of the replacement filter
Husqvarna YTH 180 (954140010D) (199712) Parts Diagram for Transaxle
quality levels and longer life, an oil lter change To change the hydrostatic transmission fluid in your husqvarna, you need to locate the transmission oil filter, drain the old oil, replace the filter and fill the transmission with new oil I managed to find a service manual that says I need just over 2qts of 20w50 motor oil.
Husqvarna Hydrostatic Transmission Diagram. Refer to the Service Journal for oil checking and changing intervals To change the hydrostatic transmission fluid in your husqvarna, you need to locate the transmission oil filter, drain the old oil, replace the filter and fill the transmission with new oil
Husqvarna AWD transmission Oil 4 Litres. Fill the transaxle with approximately 2.5 quarts or 80 ounces of fluid NOTE: Fluid change for the Swedish Riders needs to be performed by a Husqvarna Service Provider due to the complexities of the drive system